Plane such as "Scat"

Handcraft type: 
Materials: 
Category: 
Tags: 
  1. First you need to place a piece of paper long side vertically and fold it in half, fold the hand and smooth to deploy. Then connect the upper right corner of the sheet with the left side cut just above the middle, and the end point of the diagonal bend should be the same at the bottom right-hand lower corner of the sheet bumazhnog. Fold smooth and straighten hand, and then repeat all the steps on the left side (Fig. 1).
  2. The next step - the initiation of small parts on each side of the top of a sheet of paper. Then, the top sheet to bend over, from top to bottom towards the center.Now you need to bend the top right corner of the paper on the previously scheduled oblique line. After completing this step, you need to strictly vertical bend angle of the paper - from its top to the central axis of the plate (Fig. 2.).
  3. Next, you need to very carefully bend the edge of the paper, as shown in the figure - it is one of the most difficult to execute actions when creating the airplane (Fig. 3.).
  4. Next, you need to repeat the same actions on the left side of the sheet. Thereafter, edges of the wings have to dock on the central axis of the sheet (Fig. 4).
  5. As a result of actions taken at the top of the spout formed to be folded onto itself, down to the point of connection of the wings (Fig. 5).
  6. Then you need to bend in half model airplane "back" into, and wings outside. Carefully align the wings and smooth preparation, going through all the lines of the paper sheet folds (Fig. 6).
  7. Now the plane is ready to fly (Fig. 7)
First you need to place a piece of paper long side vertically and fold it in half, fold the hand and smooth to deploy. Then connect the upper right corner of the sheet with the left side cut just above the middle, and the end point of the diagonal bend should be the same at the bottom right-hand lower corner of the sheet bumazhnog. Fold smooth and straighten hand, and then repeat all the steps on the left side (Fig. 1).